Audiovox Car Alarm Installation Guide
So you want to equip your car with an audiovox car alarm system? Then you’ve come to right place, as the article below will tell you the basics on how to set up an audiovox car alarm system by yourself. It doesn’t really require much skill. With the right manual and the right materials, you can set up your car’s own alarm system without much help from the professionals.
Before you install your new audiovox car alarm, you need to gather all the materials you need like scissors, crimps, knife, solder material, solder gun, drill, test light, screw bit, screws, double-sided mounting tape, voltmeter, and a tie wrap.
Of course, you must never forget to prepare the installation manual, especially if you have absolutely no idea what to do. But if all these still seem alien to you, then go seek the assistance of certified Audiovox people, so that in case something goes wrong, somebody is there to remedy the problem.
How to install your audiovox car alarm
Installing an audiovox car alarm is the same as installing a viper alarm or any other kind of car alarm, for that matter.
First step: you have to be able to drill a hole through a rubber grommet in the firewall of your precious car and fee the wire of the siren, which you will have mounted beforehand.
Second step: connect the power wire of the viper car alarm system directly to your car’s battery.
Third step: feed the wire through the rubber grommet located on the firewall and also into the passenger compartment. Do not forget about the fuse! If you are having second thoughts about the size of the fuse, just consult with your installation manual for assurance.
Before you drill a hole in the dash where you have intentions of placing the LED status indicator, you must first mount a shock sensor. Once you have done so, feed the LED’s wire through that hole you just drilled and place the double-sided tape to the back of the LED and place it on the hole located in the dash.
Afterwards, locate the wires that work the car’s power door locks then connect the door-lock relay to the lock or unlock wires. After that, connect the alarm wire to the relay according to how the tech advisor said so.